According to the source, they had the front glass panel of the rumoured iPhone 6. This iPhone 6 glass panel is coherent as the production quality of Apple. The source uses an original iPhone 5 front glass panel as comparison to the iPhone 6 front glass panel. They have found out that whatever the production techniques, paint technology, as well as flexural strength, etc. the iPhone 6 glass panel is very similar to the iPhone 5 one.
The rumours said that this iPhone 6 front glass panel has a display size approximately 4.7 inches, compare to the current iPhone 5, it is obvious that the display of iPhone 6 are much larger in size. Certainly, the changes in size of the display will also affects the feels when the user hold the devices. It is no doubt that if the next generation of iPhone display size increase to 4.7 inches or more, there will be negative impact on controlling the device by single hand. In addition, from the hole in the front panel , we can observe that the next generation iPhone 6 front facing camera will be repositioned back to the side of the earphone jack.
While comparing with the iPhone 5 front panel, although the difference is not too obvious, we can also find that this new piece of glass panel is much more slimmer than the previous iPhone 5. Also, the details of the design of this glass has a great difference with the previous product, the edges uses cambered (arc) surface grinding process, hence when viewing from the front, there will be a slightly cambered effect, this crafting technology is similar to the 2.5D crafting technology that Nokia has used on their devices.
You may ask why Apple possibly will use the new arc crafting technology on their new iPhone 6? Actually, the reason is very simple. If you have looked through the leak pictures of the iPhone 6, the next generation of iPhone 6 will contain a more "rounded" design. The intention is even though the screen size has increased, but while combining with the new arc crafting design, it can make the user feeling that it is more comfortable when holding the device, and maximise the grip feeling. While the curved front panel is also believed to be the main changes in design of iPhone 6.
Finally, the insider also tell us that this front panel has give up on some of the original machining process used in the production of iPhone 5. Inside the earphone jack, iPhone has been using the wedge digging edge treatment since the first iPhone, but it can not be seen in the new iPhone 6 glass panel. Although the insider said that this glass panel may not be made by gorilla glass panel, while it may be made the rumoured sapphire, thus this causes Apple had to temporarily abandoned this design because of the problem in manufacture processing. However, before making further identification, we are still cautious about what we have said.
No comments:
Post a Comment